← Back to The HUT

July 1983 · Vol. 19 No. 7

July 1983 Magazine (Vol. 19 No. 7)

Issue first-page cover

Magazine · 20 pages

July 1983 Magazine (Vol. 19 No. 7)

Captured text — scan page 14

Automatically captured text may contain recognition errors. Compare it with the original scan.

This shows the complete scan page, including any other material on it.

BUILDER’S CORNER

Set up an area for mixing—any table or First shake up the resin can to mix in
work bench works. Cover your table and pro- any wax, then pour your half pint. Add the
tect it from spills. Have solvents handy for catalist about 13 to 3 ml. of catalyst with an
clean-up during and after the job is done. Ace- eyedropper, mix thoroughly.
tone is good for cleaning but is very flammable. Use a cheap 1" bruch for installing these
I keep the acetone outside. A good cleaner strips. Lay a narrowstrip on the stem, near
can be made from ammonia and dish detergent. the bottom, and proceed to wet it out with
This is much safer and cheaper than acetone. resin. Once started the resin will hold the strip
I have both on hand before I start. onto the boat as you continue to wet it out.
The last thing I do before starting to glass More working time can be had by adding
is to brush off and vacuum the hull. Remove a little less catalyst. If you used all the first
any sawdust or other contaminants. batch without jelling the resin, you may add
Now you're ready to start glassing. slightly more to speed the cure.
I don't prime my boats. If you choose Take your brush out of the solvent and
to prime I'll recommend doing it with resin. shake it clean. Go back to work on the ends.
It is my opinion that the best bond for polyester When you have completed the end with 2 layers,
resin is polyester resin. Some people prime look for starved-looking spots and rewet them.
their wood with lacquer or shellac. Some of Remember we didn't prime so some of the resin
us don't prime at all. will soak into the wood. Replace it.
I spread the glass out over the boat from Wash out your brush and clean up. Don't
end to end and trim for length. Smooth out throw out the extra resin. As the resin cures
the cloth and center it so it drapes over the it will turn hazy as the wax comes to the sur-
sides uniformly. Be sure that the fabric is flat face. Check the resin from time to time and
and smooth all over. Trim off any cloth that you will see how it cures. The surplus resin
“hangs more than an inch below the gunnels. in the pot should begin to cure first because
Keep the large trimmings clean as you will it's thicker. Any glass that hangs below the

be using them. The trimmings will usually be gunnel makes a good gauge to tell you the condi-
four triangular pieces of cloth. From these tion of the cure.

pieces I will make my bias strips (see Fig. 1). The resin reaches a point where it's

I cut strips of fabric at a 45° angle to the weave rubbery—it no longer runs but it will still bend
of the fabric as shown. These strips vary from freely. It is at this stage that you can trim

2 to 5 or 6 inches wide. Make many different with a razor blade. If the resin hardens com-
width strips. pletely before you can trim, don't worry, at

The strips that I make from scraps are least you know you got the right mixture. If
not usually long enough to completely wrap you are oa waiting for a cure after an hour
around the stems. Usually they will go half- you didn't have enough catalyst for the temp.
way and overlap halfway around. I like to use Try adding heat to the surface with a heat lamp,
these as the overlap causes extra layers of this sometimes helps. ae
glass. After another hour if the resin still hasn't

I install 4 or 5 full layers of bias cut fab- cured, check the surplus in the pot. It this —
ric on each end. The area that has the overlaps also hasn't cured, it's time to take some action.
ends up with 8 or 10 layers. This makes a dandy Get out your tools and mix up a small
erunch pad. I you are a first-time builder and batch, very hot. Double the catalyst from the
are not confident in glassing, I reeommend last batch and paint this unto the uncured sur-
that you start with a small project. Rather face. This will often cause a cure. Then, if
than do the entire bottom try glassing only the resin has not cured after a couple more
a couple bias strips on each end. This is a great hours, make a test batch. Mix a very small
place to practice. pot with 4-5 times the original catalyst. By

Fold back the main sheet of cloth and now if this batch hasn't cured after a couple
bare the ends of the boat. Mix a small batch hours, peel off the strips you've installed and
of resin, about a half pint in a container twice find an expert. Something is very wrong.
that large to give lots of splash room. Mix Bob Brown #&
thoroughly.

14 HUT!

Articles (17) · Summaries (17)

Generated issue overview: July 1983 issue of HUT!, the monthly newsletter of the Minnesota Canoe Association. It contains canoeing and paddling features, trip reports, association and DNR news, practical advice, and event information, alongside advertisements, calendars, and membership material.

Generated summaries are descriptions, not original captured text. Page-range text shows complete scan pages and may include neighboring material.

Governor Signs Proclamation

Title transcribed from original publication

Generated summary: A report describes MCA members attending Governor Rudy Perpich's signing of proclamations naming Minnesota the Canoe Capital of the United States and June Rivers Month. It also discusses a possible gubernatorial canoe trip and concerns about river litter.

Open scan page 3

Read captured page 3 →

“The Body”

Title transcribed from original publication

Generated summary: Jesse Ventura reflects on canoeing, fitness, exercise, and safety, drawing comparisons between paddling and wrestling and recommending preparation and stretching. The article continues onto the next page, where Ventura is identified as its author.

Open scan page 4

Read captured pages 4–5 →

Strok’n My Island

Title transcribed from original publication

Generated summary: A first-person account of a kayak and canoe trip on Isle Royale describes the route, weather, portages, campsites, wildlife, and the author's experiences on Lake Superior.

Open scan page 6

Read captured pages 6–7 →

Crow River

Title transcribed from original publication

Generated summary: A report on a May cruise on the Crow River describes the weather, strong current and headwind, the group's pace, and the river's scenic, wilderness-like setting near the Twin Cities.

Open scan page 7

Read captured page 7 →

Changes on Mississippi River Maps

Title transcribed from original publication

Generated summary: A DNR news item explains a change in the Mississippi River map mileage reference and describes the backwater information available on maps between Anoka and the Iowa state line. It also notes that county water-access maps are available free from the DNR.

Open scan page 8

Read captured page 8 →

Pine River Designated Canoe and Boating Route

Title transcribed from original publication

Generated summary: The item reports that the Pine River in Crow Wing and Cass counties was designated the state's nineteenth Canoe and Boating Route. It describes possible DNR management, facilities, signage, and a hoped-for guide map for the 1984 season.

Open scan page 8

Read captured page 8 →

River Level Inventory Project

Title transcribed from original publication

Generated summary: A DNR item says that more river-level inventory reports are needed to represent conditions at different water levels. It encourages reports even when gauges cannot be read and gives contacts for additional forms or gauge lists.

Open scan page 9

Read captured page 9 →

Updated Canoe and Boating Route Maps Available

Title transcribed from original publication

Generated summary: The item describes updates to maps for 31 river segments, including more information on access, crossings, gauges, rapids, dams, and other hazards. It asks river users to report errors or missing information.

Open scan page 9

Read captured page 9 →

Whitewater Canoe Course Completed, Kayak Course Begins

Title transcribed from original publication

Generated summary: A chapter-news report thanks volunteers who taught a whitewater canoe course and announces a July kayaking demonstration and an August kayak course, including its fee and enrollment limit.

Open scan page 12

Read captured page 12 →

Trip Planning

Title transcribed from original publication

Generated summary: Practical advice for planning canoe trips recommends using a gear checklist and coordinating the shuttle carefully. It cautions drivers about dust and visibility on dry dirt roads.

Open scan page 13

Read captured page 13 →

Update on New Canoe and Boating Route Facilities

Title transcribed from original publication

Generated summary: A brief facilities update reports two new canoe campsites on the Rum River, a new Mississippi River access at Belle Prairie, and a campground expected at Fletcher Creek.

Open scan page 13

Read captured page 13 →

June Designated Rivers Month

Title transcribed from original publication

Generated summary: A short report says Governor Perpich designated June as Minnesota Rivers Month and explains that the observance is intended to raise awareness and encourage conservation and revitalization of rivers.

Open scan page 13

Read captured page 13 →

Builder’s Corner

Title transcribed from original publication

Generated summary: A how-to article explains steps for applying fiberglass and polyester resin to a wooden canoe, including preparing the work area, cutting bias strips, applying resin, and handling curing problems.

Open scan page 14

Read captured page 14 →

Kevlar Soupspoons Make Me Gag

Title transcribed from original publication

Generated summary: A commentary argues that equipment-focused expectations can intimidate new MCA members. Through a family’s imagined first club trip, it advocates welcoming beginners and valuing enjoyment and practical skills over expensive gear.

Open scan page 15

Read captured page 15 →

Lung Association Trek

Title transcribed from original publication

Generated summary: An announcement describes two Minnesota Canoe Treks organized to raise funds for community health and environmental programs. It gives dates and outlines an Ontario trip and an autumn trip on Wisconsin's Kickapoo River.

Open scan page 16

Read captured page 16 →

Exercise Your Brain — Save Your Energy

Title transcribed from original publication

Generated summary: The item offers individualized instruction in open-canoe paddling technique, with an emphasis on efficient strokes and sessions tailored to participants' skill levels.

Open scan page 17

Read captured page 17 →

What the MCA Knows, the MCA Shares

Title transcribed from original publication

Generated summary: A notice describes basic canoeing classes offered by the Minnesota Canoe Association, gives the July and August dates, and explains how to arrange a class or sign up.

Open scan page 17

Read captured page 17 →