← Back to The HUT

October 1981 · Volume/issue not printed or unknown

October 1981 Magazine

Issue first-page cover

Magazine · 12 pages

October 1981 Magazine

Captured text — scan page 7

Automatically captured text may contain recognition errors. Compare it with the original scan.

This shows the complete scan page, including any other material on it.

Builders Corner ; Use a piece of roving i to 1-1/2 inches shorter than
strips of fiberglass cloth. (Two or three bundles are

recommended for heavy paddle use.) Using rubber or

plastic gloves, dip one end into the resin, then the

ONE WAY TO FIBERGLASS: other. Lay soaked-out roving on top of cloth stack.
A CANOE PADDLE Gently lift stack by ends and flip over the end of the
paddle lengthwise. Fan corner crease until it
by Al Button disappears. Make sure roving stays on tip of paddle.
Keep working, if necessary, to remove bubbles and
Fiberglassing a canoe paddle blade increases its life. creases for half an hour or longer, until resin gets
A paddle thus processed is less likely to chip or tacky. However, as soon as possible, turn paddle
erack, and the protection is a must in serious blade downward to keep resin at tip and avoid
whitewater paddling. further dripping, continuing to work strip.
Materials required are: Paddle, sandpaper or varnish Note that only roving strands are used, not the roving
remover, newspapers or plastic drop cloth, scraps of itself. The roving strands prevent the resin from
4-oz. or 6- or 7-oz. fiberglass cloth, scissors, paper chipping and cracking as unreinforced resin would do
cup, small amount of epoxy resin, waxed paper, 1- to under brutal pounding.
2-inech brush, one to three pieces (bundles) of roving
(18 1/2-oz.), rubber or plastic gloves, rag, and acetone _ Have a rag ready to wipe off drips. Use acetone to
cleaner. clean brushes when finished.

Assemble your materials. Apply sandpaper or varnish
remover to the bottom two inches of the paddle ke sx sr
blade. Tape the paddle, blade upward, to a table leg

or other similar structure. Protect floor and table
with newspapers or plastic. Bias cut two pieces of
the 6- or. 7-oz. fabric 1-1/2 inches wide by 9-10
inches long (one inch longer than paddle width—an
8-inch blade requires a 9-inch length of fabric). Trim
eorners or round ends of cloth. Bias cut two pieces
of. 4-oz. cloth similarly, except make them two inches
wide.

ANOTHER WAY TO FIBERGLASS A PADDLE
by Karl Ketter.
Remove old finish from paddle with sandpaper.

Fill cracks, splits, or gouges with thickened polyester

3 . ‘ fi resin or epoxy—whichever is more convenient.
Mix a small amount of epoxy resin, about one inch in at OP Sry PAREN

the bottom of a paper cup. (The finish of epoxy is
tougher and harder than alternate products, and it is
easier to work with because it's gluey.)

Fix blade into a horizontal position. Lay on a full
layer or strips of 4-oz. fiberglass across the blade.
Apply polyester resin. Do not attempt to fold cloth
around edges, but wet cloth to and slightly beyond

Lay a 4-oz. strip on waxed paper. Use brush to wet cnani, ‘Tye ceain. wake

strip with resin. Stack on second 4-oz. strip and wet
down. Add the 6- or 7-oz. strips one at a time,
wetting each with resin. Stretch each strip
lengthwise as you lay it down (the bias cutting
permits maximum stretchability).

Turn paddle over and repeat on other side of blade.
Let resin set.

Trim the glass that extends past the blade edges with
metal snips, coarse sandpaper, or coarse metal file.

Sand surface of blade to remove runs.

Apply second layer. of resin to fill cloth weaves and
the gap that appears at the edges between the two
layers of cloth. Option: Place a graphite fiber or
two into the groove around the edge of the blade. If
using graphite, also use epoxy for this groove.

INSIDE |NEXT TO PADDLE TIP

LAY ACcKosS TiP PUSH CPGES GF —— 2-3 ROVING STRANOS === SEES
CLOTH DOWN ee So
STRETCH - ONTO PADDLE
: FACE wiTH . ° . ;
FINGERS STRETCH QS SRNR on RCE TES SURO RET. STRETCH

WRINKLES ———_,

7 oz Bias CUT 19x" —_—

ps STRETCHED 12.
ye

SEINE Fy

wt

fil

al a

SOM taper oy SA
eels NE

Kop

| , | STREICH f-

\ fy a rn

PUSH OUT CORNER WORK OUT AMY

WRINKLES AS BULSLES . “
SHOWN bY ee
ARROWS FINISHED W035 GUT SIOE

LOOKS CCE THIS

Articles (18) · Summaries (18)

Generated issue overview: October 1981 issue of HUT!, the Minnesota Canoe Association newsletter. The issue contains canoe-trip accounts, paddling and equipment articles, association and chapter reports, conservation news, and editorial material, alongside calendars, advertisements, classifieds, and membership information.

Generated summaries are descriptions, not original captured text. Page-range text shows complete scan pages and may include neighboring material.

South American Expedition

Title transcribed from original publication

Generated summary: Mike Vande Vyver previews a presentation about the group's expedition in Peru, describing travel along the Huallaga and upper Amazon, trip preparations, equipment, and slides to be shown at an MCA program.

Open scan page 1

Read captured page 1 →

SCOUTING FOR NEW SITES

Title transcribed from original publication

Generated summary: A short piece recommends the 1981 Scouting Family Camping Directory as a way to find Boy Scout camps offering family camping, with information about availability, reservations, and facilities.

Open scan page 2

Read captured page 2 →

ANNUAL BANQUET

Title transcribed from original publication

Generated summary: Reports on the MCA annual banquet, including attendance, chapter reports, racing and cruising awards, and a presentation by members of the Peru expedition group.

Open scan page 3

Read captured page 3 →

TREASURER'S NOTE

Title transcribed from original publication

Generated summary: Explains that the MCA had to cover the cost of 13 banquet reservations for people who did not attend, and says future reservations will require payment.

Open scan page 3

Read captured page 3 →

NOVEMBER BOARD MEETING

Title transcribed from original publication

Generated summary: Reports on a joint meeting of the outgoing and incoming MCA boards, including discussion of finances, membership growth, dues, officers, publications, and educational programming.

Open scan page 3

Read captured page 3 →

A BACKWARDS GLANCE

Title transcribed from original publication

Generated summary: Mike Gilman recounts the MCA's work on the Paddler's Rendezvous '81 and explains the association's concern that a later Canoe magazine update omitted acknowledgment of its contribution.

Open scan page 4

Read captured page 4 →

MINNESOTA TRAILBOUND RECOMMENDATION

Title transcribed from original publication

Generated summary: George Skinner recommends Minnesota Trailbound outings, describing their affordability, winter activities, cabin access, and opportunities to try winter camping and equipment.

Open scan page 4

Read captured page 4 →

EDITOR'S NOTE

Title transcribed from original publication

Generated summary: The editor announces changes to the HUT! staff and planned MCA materials, invites reader submissions, and asks members to contribute equipment, cookery, and book reviews.

Open scan page 5

Read captured page 5 →

BEGINNING CANOEING

Title transcribed from original publication

Generated summary: A brief report describes an October canoeing class taught by Chris Berne at Lake of the Isles, including skill practice and an exercise in switching bow and stern positions, followed by a list of graduates.

Open scan page 5

Read captured page 5 →

SURVIVING THE WINTER

Title transcribed from original publication

Generated summary: A humorous article offers mock techniques for coping with winter canoeing cravings, from simulating wet feet and portages to deliberately imagining unpleasant paddling experiences; it concludes that spring is the real cure.

Open scan page 6

Read captured page 6 →

ONE WAY TO FIBERGLASS: A CANOE PADDLE

Title transcribed from original publication

Generated summary: Al Button describes reinforcing a canoe paddle blade with fiberglass cloth, epoxy resin, and roving, including preparation, layering, and working the resin to remove bubbles and creases.

Open scan page 7

Read captured page 7 →

ANOTHER WAY TO FIBERGLASS A PADDLE

Title transcribed from original publication

Generated summary: Karl Ketter gives an alternative method for fiberglassing a paddle, including repairing damage, applying cloth and resin to both sides, trimming the edges, and sanding the finish.

Open scan page 7

Read captured page 7 →

AI-supplied descriptive title: Twin Ports chapter year-end report

AI-supplied descriptive title

Generated summary: Chris Clay reviews the new Duluth-area chapter's first season, including whitewater and recreational outings, a local canoe race, boat building, officer elections, and plans for future activities and instruction.

Open scan page 8

Read captured page 8 →

CITIZEN VOLUNTEERS BOOST DNR PROGRAMS

Title transcribed from original publication

Generated summary: A short news item reports that nearly 10,000 unpaid citizen volunteers assisted Minnesota Department of Natural Resources programs in the year ending June 30, 1981, and notes the estimated value of their services and donations.

Open scan page 8

Read captured page 8 →

CRABS VS CONDORS

Title transcribed from original publication

Generated summary: A conservation news item discusses applying the idea of triage to endangered-species funding and the difficult choices involved in prioritizing species for protection.

Open scan page 8

Read captured page 8 →

A MERRY TIME ON THE LITTLEFORK - Part 5

Title transcribed from original publication

Generated summary: The author recounts navigating difficult Littlefork River rapids, including a close approach to a large rock and the group's run through Deadman's Rapids, followed by a hurried campsite, supper, and a comic nighttime scare. The account continues on page 11.

Open scan page 9

Read captured pages 9–11 →

CLIFFS CORNER

Title transcribed from original publication

Generated summary: Cliff Jacobson explains how to protect sleeping bags and other gear from water by layering abrasion-resistant liners with plastic, arguing that leaks often result from abrasion inside packs and bags.

Open scan page 10

Read captured page 10 →

BOUNDARY WATERS CANOE AREA, MINNESOTA

Title transcribed from original publication

Generated summary: A reprinted article describes cross-country skiing in the Boundary Waters, including access points, trails, outfitters, permits, winter camping rules, and a caution about lakes open to snowmobiles.

Open scan page 10

Read captured page 10 →