Automatically captured text may contain recognition errors. Compare it with the original scan.
This shows the complete scan page, including any other material on it.
Plane the blade area for flatness and to re-
move excess glue. Glue and clamp handle
a
Tips on pe Bape leo ee
before glueing.
i] BS
Paddle Building
by
Bill McArthur
Fig. 6
[ :
Laminated canoe paddles are easy to blade is about 13” wide by 15” long or \ |
build and with the cost of buyinga good — even a 13” round blade would work well.
one, making them is an attractive alterna- =f
tive. Very few tools are needed. Latch on
to someone with a table saw, get yourself
a can of good waterproof glue. a little The handle can then be built up, glued
spruce, a hand plane, and some sanding and clamped.
gear (an electric drill with sander is fine),
and you’re ready to begin.
I made an edge glueing jig for use on
my workbench, with which two threaded i li
rods with wing nuts soldered on the end
apply the pressure to the edge of the
weet i—a8
Fig. 3
Fig. 7
242 CLAMP TO
BENCH 224 SLIDES ON
\ BENCH
ale Several handle styles are also used and Now you're ready for shaping and sanding.
| any of these can be put on any of the
styles shown.
: r x rec
~" tote Cf)
Ge N\__]
l>
In general, I like to make handles at
least 1” wide, 1 1/8” is real good and
about | 1/8” to 1 1/4” thick. Blades can
be 1/4” or even 3/16” thick if glassed on O Saas
both sides, but remember there will be B-B &«
Ce
A-A
some loss due to planing after glueing. I
like Sitka Spruce best for most stock. .
Cedar is okay but splinters easily when “a8
. Stripping. I use cedar, mahogany or wal-
nut for accent color strips.
There are many blade shapes which
people like and any can be made in any Fig. 4
of the ways described below. The most is fairly easy on this design due to the
ae blade is about 8” wide x 18” to oo, square or flat edge. Use eee strips or
24” long. The easiest method which gives a good strands of glass — unravelled roving or
paddle is as follows: Cut strips 1/4” thick cloth does well. Wet the edge of the blade
and edge laminate, handle and blade. with resin and start to lay strands on the
1/4” edge. Saturate the strands as added.
After the first few strands, put a piece of
Fig. 5 oversized wax paper on each side of the
blade to form a channel into which to lay
L BENCH TOP
Next, I like to add fiberglass support
to the bottom edge and corners so the
paddle is not damaged on rocks. This step
wi
$ the strands. Continue building up until
Tee there is 1/8 - 1/4” of glass over the end
oA and corners of the blade and feather off
f up the sides as shown.
c :
I have made a banjo which I enjoy f
very much in shallow rocky streams. Its LA